Splasher Kits

Gladon Splasher Kit

Protects Liner
Increases Profits
Eliminates Cove Washout
Saves Hours Of Set Up Time
Complete Cove And Pad Package
Eliminates Tons Of Sand And Dirt
Allows For Set Up On Grass Or Concrete
Keeps Liner From Going Under Pool Wall

Gladon Splasher Kits offer a profitable solution to a greatly over looked problem. All pools, including smaller splasher pools require a cove to keep the liner from going out under the bottom rail. Gladon Splasher Kits are designed specifically for 12 ft. and 15 ft. round splasher pools. Each kit contains the correct amount of Budget Cove and HappyBottom® Pool Pad required for either a 12 ft. or 15 ft. pool. Splasher Kits allow pools to be set up on concrete slabs or grass and save hours of installation time and hassle associated with dirt coves and sand bases.

Gladon Budget Cove is designed for use in splasher pools and is 25% smaller than our other cove designs. Budget Cove is made with a lightweight flexible foam material. Its' unique plastic backing strip slips easily into the bottom rail holding the cove in place until pool is filled. When installed, Budget Cove replaces up to a ton of sifted earth and saves hours of hard dirty work.

HappyBottom Pool Pad can add years of life to any pool liner. Made with a special high density polyethylene foam, HappyBottom acts as a vapor barrier to keeps corrosion causing water from being trapped between the pool wall and liner. Other valuable features of HappyBottom Pool Pad include a smooth easy to clean bottom, and reduced heat loss, and added liner protection from foreign objects. Installation is simple. Just roll out and cut HappyBottom sections 6" longer than the pool diameter. Next, butted edges of cut sections are seamed together. Finally, the HappyBottom is flipped over so the tape is facing down and then the whole pool is set up on top of the pad.

	Click on a link below

Send mail to orders@gladon.com with questions or comments about this web site. Last modified: July 09, 2003
©2000